Xerox N2825 安装指导
UNIX Network
40
❖
Quick Network Install Guide
Quick Install Steps
1
Print the Configuration Sheet. Details are in this
document in Appendix A: Print The Configuration
Sheet.
document in Appendix A: Print The Configuration
Sheet.
2
Check the Configuration Sheet and verify that both
TCP/IP protocol and proper connector are enabled.
TCP/IP protocol and proper connector are enabled.
3
Go to Appendix B: Set an IP Address and perform one of
the procedures there depending on the manner in which
you wish to set your printers IP address.
the procedures there depending on the manner in which
you wish to set your printers IP address.
4
SUNOS and Solaris: Refer to the CentreWare DP user
Guide for SunOS/Solaris (English only) included on the
Printer Management Software CD-ROM for CentreWare
installation and detailed printer setup instructions.
Guide for SunOS/Solaris (English only) included on the
Printer Management Software CD-ROM for CentreWare
installation and detailed printer setup instructions.
Other UNIX OS: Load printer drivers and configure the
printer for one of the Print Models. These drivers are
available on the Printer Management Software CD-ROM
or from the Xerox Web site (ftp.xerox.com).
printer for one of the Print Models. These drivers are
available on the Printer Management Software CD-ROM
or from the Xerox Web site (ftp.xerox.com).
5
Send a print job to the printer.
6
Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
7
If your print job did not print, see the Troubleshooting
section for your operating system in the Technical
Information Guide to correct the problem.
section for your operating system in the Technical
Information Guide to correct the problem.