Xerox 200e 用户手册

There are two ways to run BOOTP: 

■

If the bootpd daemon is started within the /etc/rc.local Þle or a 
similar startup Þle, it is always running and waiting for BOOTP 
requests. This method uses system resources at all times.

■

If the bootpd daemon is started within the /etc/inetd.conf Þle, it 
starts bootpd only when a BOOTP request arrives, conserving 
system resources.  

If the bootpd command line does not exist in your /etc/rc.local Þle, 
you need to add it. To verify that the bootpd startup command is 
in the Þle, type:

If the bootpd startup command is in the Þle, the following line is 
displayed.  The -s option speciÞes continuous execution.

/etc/bootpd -s ;     echo -n Õ bootpdÕ

Verify that bootpd resides where it is speciÞed in /etc/rc.local. For 
the preceding examples, bootpd would be located in /etc. If there 
is a mismatch between the actual location and the speciÞed 
location, either move the bootpd binary or change the /etc/rc.local 
Þle.

The port numbers for BOOTP listening and replying must be set in 
the /etc/services Þle. If they are not set, edit the Þle and add them. 
To verify that the ports are set in the Þle, type:

If the ports are set in the Þle, the following line is displayed:

bootps 67/udp

bootpc 68/udp