Xerox 2135 用户指南
Advanced Features and Troubleshooting Manual
127
Networking
Quick Step (OS/2 Warp Server V 4.0)
To install and use your Phaser 2135 printer in an IBM Warp Server environment, you need
to perform several administrative tasks in order to install the printer and configure your
server.
server.
Quick Install Setup
1.
Network Cable Connection - Attach RJ45/DB15/ BNC.
2.
Configuration Page - Print the Configuration Page from the Front Panel.
3.
Create OS/2 Printer Object - Install/create printer driver & printer and share.
4.
Test Print - Start LPRPORTD/LPRMON, ping printer, open EPM and test print.
5.
Print Quality - Print the Print Quality Tips page.
Troubleshooting
1.
Check cables/drops. Are the LEDs active?
2.
Print Settings. Check Enabled=ON, IPADDRESS=dhcp/ bootp/static (make sure the IP
Address resolution is set properly. Use DHCP if your network uses a DHCP server to
assign IP addresses. Use BOOTP if your network uses BOOTP to assign IP addresses,
assign IP addresses. Use BOOTP if your network uses BOOTP to assign IP addresses,
and use STATIC if you wish to assign a specific IP address).
Note
You may set a Static IP Address from the front panel.
3.
Printer Properties - Using LPD Output Port. WIN-OS2 using LPRMON.
4.
Watch LPRPORTD Screen - Is there Activity? In printer input light processing?
5.
It may take a few prints before initial quality responds. Print 10-20 pages first.