Xerox 2135 用户指南

Step-by-Step Setup for IBM TCP/IP for OS/2

TCP/IP Protocol Configuration

Acquire two IP addresses for use on your server and your Phaser 2135 printer.

Install TCP/IP for OS/2. Remember to open LAN Adapter and Protocol Support 

(LAPS/MPTS, etc.) and configure the TCP/IP protocol for your network adapter. (See 
your OS/2 documentation for configuring network adapters for the TCP/IP protocol.)

Open (double-click) TCP/IP Configuration Object.

■

Click the Printing tab and enter the following:

■

REMOTE PRINT SERVER = Printer IP Address in 32-bit dotted decimal notation 

(e.g., 127.0.0.0).

■

REMOTE PRINT SERVER’S PRINTER = ps (Enter ps without quotes and in 

lowercase.)

■

MAXIMUM NUMBER OF LPD PORTS = Enter a number between 2 and 64 
inclusive.

■

FOR OS/2 PRINTING ONLY (NO WIN-OS/2) Click the Autostart tab. Highlight 

lprportd, then click Autostart Service, Foreground Session and Minimized.

■

Close the TCP/IP Configuration Windows. Click SAVE, then reply YES to Update 

CONFIG.SYS.

■

Shutdown your server/workstation and reboot.

Once completed and you have rebooted, use the “ping” command at an OS/2 

Command Prompt to ping your server/workstation’s IP address. Repeat the ping 
command using your Phaser 2135 printer’s IP Address to confirm that your 

printer is configured properly for using TCP/IP.