Xerox 360 补充手册

063-2434-03

Repacking the Color Printer
and Its Accessories

Overview

It is very important that you follow the correct repacking procedure before shipping the color printer.
Complete repacking is required. Failure to properly repack the printer can damage the printer’s internal
components.

You are responsible for any shipping damage to the printer that results from improper or

inadequate packaging.

Repacking for shipment consists of five basic tasks. Each of these tasks is explained below. If you have
questions regarding any of the repacking procedures, call the Tektronix Customer Support Hotline at

1-800-835-6100

, or contact Tektronix online at

www.tek.com/Color_Printers/support/

Turn off the printer using the

On/Off

switch.

Wait 30 minutes before moving the printer to allow the ink to solidify.

Remove the maintenance tray, seal it in a plastic bag, and store the tray on a flat

surface.

A used maintenance tray leaks drum fluid if tipped.

Lock the printhead transit restraint on the right side of the printer.

Repack the printer and its accessories using Tektronix-approved packing materials.

Turning off the printer

Use the rear-panel

On/Off

switch to turn off the printer. Doing so places the printhead in the proper

position for locking (described below), which is necessary for safe shipment.

Do not turn off the printer by

pulling the power cord.

Caution

To avoid damaging the printer’s internal components, always turn the printer

power off using the

On/Off

switch. Failure to do so may result in damage to the

printer’s internal components during shipment.

Waiting for 30 minutes

After turning off the printer, let it cool down for at least 30 minutes before you move

it so that the melted ink inside the printer has time to solidify.

Disconnect the power cord and other cables from the printer.

Remove the media tray from the printer.

If present, disconnect the Lower Paper Tray Assembly cable from the printer.