Xerox 380 安装指导

Installing the Printer Station

Location requirements

Before unpacking the Printer Station, prepare an area that allows appropriate clearances for proper

ventilation of the printer. Install on a level ßoor surface, allowing for no more than 1.3 cm (0.5 in.) tilt

from level across any side of the Printer Station.

Turning off the printer

Before unpacking the Printer Station, prepare the printer to be moved by turning it off using the On/Off

switch located on the rear panel. Allow at least 45 minutes for the printer to cool before moving it.

Use the rear-panel

On/Off

switch to turn off the printer. This places the printhead in

a safe position for moving the printer a short distance. If you are moving the printer

a long distance, remove the maintenance tray and lock the printhead transit

restraint. Refer to the printerÕs user manual for more information.

Caution

After turning off the printer, wait 45 minutes before moving it to allow the ink in the
printer to solidify. Failure to do so can result in ink spills that can damage the printer.

After the printer powers down, disconnect the power cord and other cables.

If present, disconnect the Lower Paper Tray Assembly cable from the printer.

Unpacking the Printer Station

Using a utility knife, cut open the Printer Station shipping box from the top to the

bottom at each corner.

Warning

The Printer Station weighs 31.4 kg. (69 lbs.). Do not attempt to lift it without the
assistance of another person.

Lift the Printer Station from the Printer Station shipping box.

Printer Station Dimensions

Printer Clearances

Product Weights

Height: 51.5 cm (20.25 in.)

Top: 45.7 cm (18 in.)

Printer Station: 31.4 kg (69 lbs.)

Width: 59.7 cm (23.5 in.)

Right Side: 10.2 cm (4 in.)

Printer: 100 kg (220 lbs.)

Depth: 62.2 cm (24.5 in.)

Rear: 10.2 cm (4 in.)

Lower Paper Tray: 36.8 kg (81 lbs.)

Left Side, Front, Bottom:
no restrictions

Combined Total: 168.2 kg (370 lbs.)

2818-02

Min.