Xerox 380 补充手册

063-2659-00

Repacking the Color Printer
and its Accessories

Overview

It is very important that you follow the correct repacking procedure before shipping your color printer.

Failure to properly repack the printer can cause damage to the printerÕs internal components.

You are

responsible for any shipping damage to the printer that results from improper or inadequate
packaging.

Repacking for shipment consists of four basic tasks. Each of these tasks is explained in this instruction

sheet. If you have questions regarding any of the repacking procedures, call the Tektronix Customer

Support Hotline at

1-800-835-6100

■

Turn off the printer using the

On/Off

switch and wait

45 minutes

before moving it to

allow the ink to solidify.

■

Remove the maintenance tray, seal it in a plastic bag, and store the tray on a ßat

surface.

A used maintenance tray leaks drum fluid if tipped.

■

Lock the printhead transit restraint on the right side of the printer.

■

Repack the printer and its accessories using Tektronix-approved packing materials.

Turning off the printer

Use the rear-panel

On/Off

switch located on the rear of the printer to turn it off.

This places the print head in the proper position for locking (described later in this

document), which is necessary for safe shipment. Do not turn off the printer by

pulling the power cord.

Caution

To avoid damaging the printer’s internal components, always turn the printer

power off using the

On/Off

switch before moving or shipping the printer. Failure

to do so may result in damage to the printers’ internal components during
shipment.

After turning off the printer, let it cool down for at least

45 minutes

before you move

it so that the melted ink inside the printer has time to solidify.

Disconnect the power cord and other cables from the printer.

Unload any media present in the media tray. Install the tray in the printer.

If present, disconnect the Lower Paper Tray Assembly cable from the printer.