Xerox 560 用户手册

 

Frequent media jams

Make sure that you use a high-quality laser paper:  75-105 g/m2 (20-28 lb.) paper in the 
media trays and 75-120 g/m2 (20-32 lb.) paper in the Multi-Purpose Feeder.  Refer to 
“Media hints and tips” on page 7-38 for more information.

Make sure that the Media Thickness switch is set correctly for the media installed in the 
Multi-Purpose Feeder.  If the printer has frequent paper jams, set the Media Thickness 
switch to a thicker setting.  Refer to

 

“Setting media thickness” on page 4-41 for more 

information.

If you are using media that is 120 g/m

 

2

 

 (28 lb.), check if the 

 

 media output 

setting is selected in the driver.  If it is, change the setting to 

 

.  If the problem 

persists, use the Multi-Purpose Feeder rather than a media tray.

Use only Tektronix transparencies that are listed on the supplies information sheet.  
Tektronix does not guarantee the results of non-Tektronix transparencies in Tektronix 
printers.  

Make sure that the media is installed under the hooks at the front of the media tray.

Do not overfill the media tray, as indicated by the red line on the right side of the tray.  

Clean the paper-feed rollers and paper-pick rollers.  See page 6-12 for instructions.

 

Off-set images

Check your application for correct image sizing.

Cut-off images

Check your application for image sizing.

Make sure that you are using a Phaser 560 printer PPD file and have selected the 
correct page size. 

Make sure that the correct size media is in the media tray.

Image shifts or margins 
are incorrect (Macintosh)

Make sure that you have installed the Phaser 560 printer driver, the Phaser 560 GX 
printer driver, or the correct PPD file onto your Macintosh so that you can select the 
correct page sizes from the driver.  For details on the driver, refer to the topics on the 
printer’s CD-ROM or the Tektronix World Wide Web site.  For details on how to print from 
a Macintosh, refer to “Printing from a Macintosh” on page 4-12.

If printing on transparencies and you have a Lower Tray Assembly installed, make sure 
that the 

 

TRANSPARENCY

 

 tray is installed in the Upper or Middle tray slot.