Xerox 750P 用户指南

Error codes

If the printer’s front panel displays a message Error XX, find the error code in this table 
and follow the instructions for resolving the problem. If problems persist, check the 
Tektronix web site www2.tek.com/TekSMART/ or contact service. 

 

Error 01

■

Remove and re-install the black Toner Cartridge, then turn the printer off and 

on.

■

Replace the black Toner Cartridge, then turn the printer off and on.

Error 02

■

Remove and re-install the cyan Toner Cartridge, then turn the printer off and 

on.

■

Replace the cyan Toner Cartridge, then turn the printer off and on.

Error 03

■

Remove and re-install the magenta Toner Cartridge, then turn the printer off 

and on.

■

Replace the magenta Toner Cartridge, then turn the printer off and on.

Error 04

■

Remove and re-install the yellow Toner Cartridge, then turn the printer off and 

on.

■

Replace the yellow Toner Cartridge, then turn the printer off and on.

Error 05, 10

, 

11

, 

12

, and 

13

■

Turn the printer power off, then on.

Error 20

■

Remove and re-install the Imaging Unit (make sure that Imaging Unit is locked 

in place). Turn the printer off, then on.

■

Remove and re-install the Main Charge Grid. Turn the printer off, then on.

■

Remove and re-install the Transfer Kit. Turn the printer off, then on.

■

Remove and re-install each of the Toner Cartridges. Turn the printer off, then 

on.

■

Replace the Main Charge Grid. Turn the printer off, then on.

■

Replace the Imaging Unit (make sure that Imaging Unit is locked in place). Turn 

the printer off, then on.

■

Replace the Transfer Kit. Turn the printer off, then on.

■

Replace the Toner Cartridges. Turn the printer off, then on.

Error 21

, 

22

, 

30

, and 

32

■

Remove and re-install the Imaging Unit (make sure that Imaging Unit is locked 

in place). Turn the printer off, then on.

■

Replace the Imaging Unit (make sure that Imaging Unit is locked in place). Turn 

the printer off, then on.

■

Error 33

■

Check for jammed paper throughout the paper path (especially in paper feeder). 

■

Remove and re-install the paper feeder and Transfer Kit. Turn the printer off, 

then on.

Error 40

, 

41

, 

42

, and 

43

■

Check for jammed paper in the Fuser. Re-install the Fuser. Turn the printer off, 

then on.

■

Make sure that you have the correct Fuser for your local printer power supply:

110-Volt Fuser

Part Number 016-1839-00

220-Volt Fuser

Part Number 016-1840-00

■

Replace the Fuser. Turn the printer off, then on.

Error 50

, 

51

■

Turn the printer off, then on.