Xerox 8855 补充手册

XES Synergix 8855 Controller Setup Manual for Firmware 7.0

6

The controller has four status LEDs in on the front panel. The functions of
these LED’s are as follows:

•  LED1 – Color Green, labeled “Ready” –Indicates the controller is

powered-up and ready to process incoming jobs.

•  LED2 – Color Green, labeled “Busy” –Indicates the controller is busy

processing a job.

•  LED3 – Color Yellow, labeled “Mismatch” –Indicates either a media

mismatch has occurred and is blocking the job queue or a Job
Accounting error has occurred.

•  LED4 – Color Red, named “Attention” –Indicates an printer or finisher

fault occurred, or a paper jam, or out of toner or media, or a
communications problem with one of the devices.

During power-on self-test (POST), the AccXES software turns on LEDs 2,3,
and 4. After POST has successfully completed, LEDs 2,3, and 4 are
extinguished and LED 1 is turned on. If POST did not successfully complete
and the controller is not able to go into “Ready” state, all four LEDs are
extinguished.

LED2

LED1

LED3

LED4