Gestetner c7528 操作指南
Monitoring and Configuring the Printer
237
IP address:0.0.0.0
Access type:read-write / trap off
Access type:read-write / trap off
• If “-p” is added, you can view settings one by one.
• To display the current community, specify its registration number.
❖ Display
msh> snmp ?
❖ Community name configuration
msh> snmp “number” name “community_name”
• You can configure ten SNMP access settings numbered 1-10.
• The printer cannot be accessed from SmartDeviceMonitor for Admin or
SmartDeviceMonitor for Client if “public” is not registered in numbers 1-10.
When changing the community name, use SmartDeviceMonitor for Admin
and SNMP Setup Tool to correspond with printer settings.
When changing the community name, use SmartDeviceMonitor for Admin
and SNMP Setup Tool to correspond with printer settings.
• The community name can be entered using up to 15 characters.
❖ Deleting community name
msh> snmp “number” clear name
❖ Access type configuration
msh> snmp “number” type “access_type”
❖ Protocol configuration
msh> snmp {ip | ipx} {on | off}
• Use the following command to set protocols “active” or “inactive”: If you set
a protocol “inactive”, all access settings for that protocol are disabled.
• Specify “ip” for TCP/IP, or “ipx” for IPX/SPX.
• {on} means “active” and {off} means “inactive”.
• IEEE 1394 interface is available for TCP/IP only.
❖ Configuration of protocol for each registration number
msh> snmp “number” active {ip | ipx} {on | off}
• To change the protocol of access settings, use the following command.
However, if you have disabled a protocol with the above command, activat-
ing it here has no effect.
ing it here has no effect.
Access type
Type of access permission
no
not accessible
read
read only
write
read and write
trap
user is notified of trap messages