Epson LX-300 规格指南
6. Slide the left edge guide to the center until it stops at the
guide mark. Then slide the right edge guide to the
opposite guide mark.
opposite guide mark.
7. Turn on the printer. The PAUSE light flashes briefly, then
stays on.
8. Make sure the printer cover is closed. Press the LF/FF
button to feed the paper to the loading position. When the
printer receives data, it begins printing automatically.
printer receives data, it begins printing automatically.
9. When you finish printing (the printer receives no data for
three seconds) the printer feeds the perforation of the
continuous paper to the edge of the printer cover so that
you can tear off the last sheet. The PAUSE light flashes.
continuous paper to the edge of the printer cover so that
you can tear off the last sheet. The PAUSE light flashes.
Note:
Set the Auto tear off feature in the Printer Setting mode to on.
Otherwise, the printer does not feed the perforation to the edge of
the printer cover.
Set the Auto tear off feature in the Printer Setting mode to on.
Otherwise, the printer does not feed the perforation to the edge of
the printer cover.
If the perforation and the edge of the printer cover do not match,
adjust the paper position by following the steps in “Adjusting the
loading position,” while the PAUSE light is flashing.
adjust the paper position by following the steps in “Adjusting the
loading position,” while the PAUSE light is flashing.
When you send more data, the paper automatically feeds
back to the loading position. If you want to change the
position where printing begins on the page, adjust the
loading position.
back to the loading position. If you want to change the
position where printing begins on the page, adjust the
loading position.
Printing with the pull tractor
F
Caution:
When using the pull tractor, set the Auto tear off feature in the
Printer Setting mode to off; otherwise the paper may jam.
When using the pull tractor, set the Auto tear off feature in the
Printer Setting mode to off; otherwise the paper may jam.
1. Turn the printer off; then remove the paper guide. Pull the
paper-release lever forward to the continuous paper
position.
position.
2. Squeeze the tractor’s lock tabs gently and pull the tractor
away from the printer.
3. Lift the tractor forward to the mounting slot at the top of
the printer and tilt it into place as shown below. When
you push the tractor onto the posts, you should feel the
notches snap into place.
you push the tractor onto the posts, you should feel the
notches snap into place.
4. Release the sprocket units by pulling the sprocket locks
forward.
(3621ý/;ðêíí
(3621ý/;ðêííðìí
éîëëîäé
,QNý-HWý3ULQWHUV