Cisco 3560x-24p 参考指南
B-11
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug dtp
debug dtp
Use the debug dtp privileged EXEC command to enable debugging of the Dynamic Trunking Protocol
(DTP) activity. Use the no form of this command to disable debugging.
(DTP) activity. Use the no form of this command to disable debugging.
debug dtp {aggregation | all | decision | events | oserrs | packets | queue | states | timers}
no debug dtp {aggregation | all | decision | events | oserrs | packets | queue | states | timers}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug dtp command is the same as the no debug dtp command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
aggregation
Display DTP user-message aggregation debug messages.
all
Display all DTP debug messages.
decision
Display the DTP decision-table debug messages.
events
Display the DTP event debug messages.
oserrs
Display DTP operating system-related error debug messages.
packets
Display DTP packet-processing debug messages.
queue
Display DTP packet-queueing debug messages.
states
Display DTP state-transition debug messages.
timers
Display DTP timer-event debug messages.
Release
Modification
12.2(53)SE2
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
Displays DTP information for the switch or for a specified interface.