Cisco 3560x-24p 参考指南
B-13
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug etherchannel
debug etherchannel
Use the debug etherchannel privileged EXEC command to enable debugging of the
EtherChannel/PAgP shim. This shim is the software module that is the interface between the Port
Aggregation Protocol (PAgP) software module and the port manager software module. Use the no form
of this command to disable debugging.
EtherChannel/PAgP shim. This shim is the software module that is the interface between the Port
Aggregation Protocol (PAgP) software module and the port manager software module. Use the no form
of this command to disable debugging.
debug etherchannel [all | detail | error | event | idb]
no debug etherchannel [all | detail | error | event | idb]
Syntax Description
Note
Though visible in the command-line help strings, the linecard keyword is not supported.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
If you do not specify a keyword, all debug messages appear.
The undebug etherchannel command is the same as the no debug etherchannel command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all
(Optional) Display all EtherChannel debug messages.
detail
(Optional) Display detailed EtherChannel debug messages.
error
(Optional) Display EtherChannel error debug messages.
event
(Optional) Debug major EtherChannel event messages.
idb
(Optional) Display PAgP interface descriptor block debug messages.
Release
Modification
12.2(53)SE2
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
Displays EtherChannel information for the channel.