Cisco 3560x-24p 参考指南
B-14
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug fastethernet
debug fastethernet
Use the debug fastethernet privileged EXEC command to enable debugging of the Ethernet
management port. Use the no form of this command to disable debugging.
management port. Use the no form of this command to disable debugging.
debug fastethernet {af | events | packets}
no debug fastethernet {af | events | packets}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug fastethernet {af | events | packets} command is the same as the no debug fastethernet
{af | events | packets} command.
{af | events | packets} command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
af
Display Ethernet management port software-address-filter debug messages.
events
Display Ethernet management port event debug messages.
packets
Display Ethernet management port packet debug messages.
Release
Modification
12.2(53)SE2
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
Displays information about the Ethernet management port.