Cisco 3560x-24p 参考指南
B-49
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform ip arp inspection
debug platform ip arp inspection
Use the debug platform ip arp inspection privileged EXEC command to debug dynamic Address
Resolution Protocol (ARP) inspection events. Use the no form of this command to disable debugging.
Resolution Protocol (ARP) inspection events. Use the no form of this command to disable debugging.
debug platform ip arp inspection {all | error | event | packet | rpc}
no debug platform ip arp inspection {all | error | event | packet | rpc}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug platform ip arp inspection command is the same as the no debug platform ip arp
inspection command.
inspection command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all
Display all dynamic ARP inspection debug messages.
error
Display dynamic ARP inspection error debug messages.
event
Display dynamic ARP inspection event debug messages.
packet
Display dynamic ARP inspection packet-related debug messages.
rpc
Display dynamic ARP inspection remote procedure call (RPC) request debug
messages.
messages.
Release
Modification
12.2(53)SE2
This command was introduced.
Command
Description
Displays the dynamic ARP inspection configuration and operating state.
show debugging
Displays information about the types of debugging that are enabled.