LG LSW630B 用户指南

How to attach to masonry walls

- Check the material and thickness of the wall.

- When installing the product on wall material not designated, install the product so that each screw location can

withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.

a. Use an

8 mm drill bit to drill a hole for the anchor location within a depth of 80 mm - 100 mm

b. Clean the drilled hole.

c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)

d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face

upward.

e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm.

- Use an

8 mm drill bit for concrete and hammer (Impact) drill.

Wall mount screw

Anchor

Installation method

Attaching the mounting bracket to the TV

If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the

screw and refer to the technical service manual.

- Tools you will need : Phillips head "+" driver(Manual or motorized)

Ø4 mm drill bit for wood or steel / Level / Stud finder / Drill.

You may also need an 8 mm socket wrench or an 8 mm drill bit for concrete.

- The actual product may differ from the illustrations in this manual.

- If the diagonal length of TV screen is 182 cm or more, please consult with a professional installer prior to installing the TV with a

wall mounting bracket.

1. Check to see if the display has screws installed

into the mounting holes. If so, remove those.

2. Assemble the guide spacers to the set by

tightening the screws as shown in the picture.

Use a Phillips head "+" driver (Manual or

motorized) to tighten the screws. Tighten each

screw until the set, guide spacer, and the screw

are fully pressing against one another.

Guide spacer

screw

Please follow the directions below.