LG LSW630B 用户指南

- Check the material and thickness of the wall.

- When installing the product on wall material not designated, install the product so that each screw location can

withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.

a. Use an

8 mm drill bit to drill a hole for the anchor location within a depth of 80 mm - 100 mm

b. Clean the drilled hole.

c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)

d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face

upward.

e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm.

- Use an

8 mm drill bit for concrete and hammer (Impact) drill.

Wall mount screw

→

If it’s not possible to use the indicated bolt holes, use

the closet ones. Don’t go more than two away from
the indicated position.

→

Attach the right and left side with two bolts each.

→

Use a Phillips head "+" driver (Manual or motorized)

or 8 mm wrench to tighten the screws. Tighten each

screw until the set, guide spacer, and the screw are
fully pressing against one another.

1. Check to see if the display has screws installed

into the mounting holes. If so, remove those.

2. Assemble the guide spacers to the set by

tightening the screws as shown in the picture.

Use a Phillips head "+" driver (Manual or

motorized) to tighten the screws. Tighten each

screw until the set, guide spacer, and the screw

are fully pressing against one another.

a. Locate and mark the centers of the wall studs using a stud finder.

b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and

then remove the wall bracket.

c. Use a level to make sure your screw marks are level.

d. Use the

4 mm drill bit for wood to drill holes with the depth of 76 mm or above where the wall mount screw location is

marked on the wall.

e. Clean the drilled hole.

f. Tighten the wall mount screws for the wall bracket on the drilled hole.

→ At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another.

(Drywall can be damaged when tightened with excessive force, please be careful.)

→ When tightening the screw use the "+" driver (Manual or motorized) or 8 mm wrench.

406 mm

drywall

76 mm

drywall

wood stud

How to install the wall mount