Canon PRISMAdirect 手册

[Broadcast to local net-
work]

Use this discovery method when printers are connected to the lo-
cal network.
SNMP enabled printers that recognise this type of broadcast will
respond.

NOTE

Not all SNMP enabled printers respond to the broadcast.

[Scan range]

Use this discovery method when printers are connected to anoth-
er subnet of the network than the local network.

NOTE

When you have multiple network cards in your system
you should use the scan range discovery method.

Scan a range of IP addresses for SNMP enabled printers from the
lowest to the highest IP address.

[Scan subnet]

Use this discovery method when you network is divided into sub
networks.
Scan the defined subnet for SNMP enabled printers. The system
uses the subnet mask to determine the scan range. You can
change the subnet mask.

Click [Search] to start the discovery of printers.

Or you can define the additional settings for [Advanced...] first.

Click the[Advanced...] button to define SNMP parameters. These parameters are used during the
scan process. Some of them are also used to configure the discovered printers.

Scan process properties

[Retries:]

Define how many times the tool tries to contact a printer.

[Timeout (ms):]

Define the response timeout of a printer in ms.

You can select which SNMP version is supported by the printer:
• SNMP V1
• SNMP V3

You can define the following settings when you select SNMP V1:

Settings SNMP V1

[Read community:]

The read community name is used to identify the group of devices
that support printer monitoring.
Default value 'public'.

You can define the following settings when you select SNMP V3:

PRISMAdirect v1.2