Canon DIGISUPER 76 手册

E2

E3

1  HOW TO MOUNT

The servo demand is mounted and connected as shown in 
the figure below. When mounting the various demands, refer 
to the operation manual for the respective demand.

① Servo module

② Zoom servo demand

③ Focus servo demand

④ Demand cable

It is necessary to mount the servo module to the zoom and 
focus couplings located in the bottom compartment of the 
lens.

The same servo module is used for both zoom and focus couplings. 
So, it can be mounted on either the zoom or focus coupling.

  Before mounting a module to the lens, turn the lock 

screw of the module counterclockwise until the lock 
axis comes out to its a half way of length.

  Press the module in the direction of arrow “A”, so 

that the key pins on the lens are inserted in the key 
grooves of the module.

Coupling B

Index Line

(White Line)

Arrow 

A

Key 

Groove

Lock Axis

Lock Screw

Servo Module

Coupling A

Key Pin

  Mate the coupling A of the module with the coupling 

B of the lens. And then, fully push the module in the 
direction of arrow “B” until it stops.

  Finally, turn the lock screw of the module clockwise to 

secure it. By using a coin, tighten firmly the lock knob.

Arrow B

Lock Screw

Lock

Next, as the same procedure, install the servo module on 
the other joint. It does not matter which is installed first, 
either the zoom or the focus.

When mating couplings A and B, push the servo module in 
completely, so that the index line (white line) on the circumference 
of coupling B is entirely hidden. If index line is not completely 
hidden, the servo module may fail to operate, or it may generate 
abnormal acoustic noise.

  Mount the switch box to the panhandle of the tripod, 

using the attached clamp.

  Connect the switch box to the lens, using the included 

cable.