Canon EOS C300 Mark II 手册
14
The camera will automatically detect access points in the vicinity. After you select the desired
access point, you only need to enter the selected network’s encryption key (password) to
connect the camera. For details about the encryption key, refer to the instruction manual of the
wireless router or consult the network administrator.
access point, you only need to enter the selected network’s encryption key (password) to
connect the camera. For details about the encryption key, refer to the instruction manual of the
wireless router or consult the network administrator.
1
Push the joystick up/down or turn the
SELECT dial to select the desired
access point and then press SET.
SELECT dial to select the desired
access point and then press SET.
If the access point is encrypted (C), continue the
procedure to enter the encryption key (password).
Otherwise, continue directly with the procedure to
configure the IP address assignment (A 16).
procedure to enter the encryption key (password).
Otherwise, continue directly with the procedure to
configure the IP address assignment (A 16).
햲 Encrypted access point
햳 Network name (SSID)
햴 Current access point/Total number of active access points detected
햳 Network name (SSID)
햴 Current access point/Total number of active access points detected
2
Select the WEP index key.
This step is only necessary if the Wi-Fi network’s
authentication method is set to [Shared Key] or if
the encryption method is set to [WEP].
authentication method is set to [Shared Key] or if
the encryption method is set to [WEP].
3
To change the [Encryption Key]
(password), select [Input] and then
press SET.
(password), select [Input] and then
press SET.
Enter the encryption key (password) using the
keyboard screen (A 10).
keyboard screen (A 10).
After confirming the encryption key (password),
continue with the procedure to configure the IP
address assignment (A 16).
continue with the procedure to configure the IP
address assignment (A 16).
Searching for Access Points
햲
햳
햴
[WEP]/[Shared Key]
Valid encryption keys vary depending on the encryption method.
64-bit WEP encryption:
64-bit WEP encryption:
5 ASCII characters or 10 hexadecimal characters.
128-bit WEP encryption:
13 ASCII characters or 26 hexadecimal characters.
AES / TKIP encryption:
8 to 63 ASCII characters or 64 hexadecimal characters.
* Note: ASCII characters include the numbers 0 to 9, the letters a to z and A to Z and some punctuation marks and
special symbols. Hexadecimal characters comprise the numbers 0 to 9 and the letters a to f and A to F.