Canon EOS C300 Mark II 手册
18
Initially, basic default network settings for a browser connection are already saved in the
camera. You can check these settings on the status screens (A 21). With the following
procedures you can change the default settings, if you prefer.
camera. You can check these settings on the status screens (A 21). With the following
procedures you can change the default settings, if you prefer.
[Camera ID]
A unique camera identification code that will appear on the Browser
Remote screen. This is convenient if you are using a multi-camera
shooting setup.
Remote screen. This is convenient if you are using a multi-camera
shooting setup.
[Port No.]
The port number (HTTP protocol) used by Browser Remote. This is usually
set to port 80, but you can change it if necessary.
set to port 80, but you can change it if necessary.
1
Set the camera to
mode and open
the [Camera ID] submenu.
[w System Setup] > [Network Settings] > [Browser
Remote] > [Camera ID]
Remote] > [Camera ID]
2
To change the camera ID, select [Input]
and then press SET.
and then press SET.
Enter the desired camera ID (up to 8 characters)
using the keyboard screen (A 10).
using the keyboard screen (A 10).
3
To change the port number, select [Port
No.] and then press SET.
No.] and then press SET.
Using the default number is recommended.
To change the port number, push the joystick left/
right to select the digit you wish to change and
then push the joystick up/down to select the digit.
After completing all the digits, select [Set] and then
press SET to confirm.
right to select the digit you wish to change and
then push the joystick up/down to select the digit.
After completing all the digits, select [Set] and then
press SET to confirm.
Browser Remote: Camera Settings