Canon EOS C300 Mark II PL 手册
33
Error Messages
Unable to complete WPS.
The access point’s encryption method is set to [WEP]. Wi-Fi Protected Setup
(WPS) cannot connect to access points set to this encryption method.
(WPS) cannot connect to access points set to this encryption method.
X
Change the access point’s encryption method or use another connection method (A 7).
Unable to complete WPS. Try the operation again.
More than 2 minutes passed between activating WPS on the access point and
selecting [OK] on the camera.
selecting [OK] on the camera.
X
Start over the WPS procedure from the beginning.
The WPS button was not held down long enough.
X
Refer to the instruction manual of your wireless router. When using WPS to make a
wireless connection, keep the WPS button held down until the wireless router’s WPS
function is activated.
wireless connection, keep the WPS button held down until the wireless router’s WPS
function is activated.
Unable to connect
Could not connect to the access point or network device selected.
Cordless phones, microwave ovens, refrigerators and other appliances may
interfere with the wireless signal.
interfere with the wireless signal.
X
Try using the camera in a location farther away from such appliances.
Unable to obtain an IP address
X
If you are not using a DHCP server, connect using the [Manual] option and enter the IP
address using the [Manual] option (A 15).
address using the [Manual] option (A 15).
X
Turn on the DHCP server. If it is already on, make sure it is functioning properly.
X
Make sure the address range for the DHCP server is sufficient.
WFT Error Check the Wi-Fi settings.
Some of the network settings saved in the camera are not compatible with the
transmitter attached.
transmitter attached.
X
Change the network settings or reset all the camera’s settings to use the default network
settings.
settings.
Wi-Fi authentication unsuccessful
X
Check the access point’s authentication/encryption method and encryption key and
change the camera’s network settings (A 5) as necessary.
change the camera’s network settings (A 5) as necessary.
Wi-Fi error. Incorrect authentication method.
X
Check the access point’s authentication/encryption method and change the camera’s
network settings (A 5) as necessary.
network settings (A 5) as necessary.
Wi-Fi error. Incorrect encryption key.
When the authentication mode was set to [WPA-PSK] or [WPA2-PSK], or the
encryption method was set to [WEP], the encryption key (WEP index) entered or
its length (number of characters) is incorrect.
encryption method was set to [WEP], the encryption key (WEP index) entered or
its length (number of characters) is incorrect.
X
When entering ASCII characters, enter 5 characters (64-bit encoding) or 13 characters
(128-bit encoding). When entering hexadecimal characters, enter 10 characters (64-bit
encoding) or 26 characters (128-bit encoding).
(128-bit encoding). When entering hexadecimal characters, enter 10 characters (64-bit
encoding) or 26 characters (128-bit encoding).