Netgear FVS318N – Prosafe Wireless N VPN Firewall 产品宣传页

IPv4 Routing Commands

This command configures an IPv4 static route. After you have issued the net routing 
static ipv4 configure 

command to specify the name of the new route, you enter the 

net-config [static-routing-ipv4] mode, and then you can configure one keyword and 
associated parameter or associated keyword at a time in the order that you prefer. 

net

net-config [static-routing-ipv4]

 or N 

Specifies whether or not the route is an active 
route.

 or N 

Specifies whether or not the route can be shared 
with other gateways when RIP is enabled.

The destination IP address.

The destination subnet mask.

custom_vlan <VLAN 

name>, dmz, lan, or wan

Specifies the interface for which the route is 
applied. The DMZ, LAN, and WAN interfaces are 
self-explanatory. If you select the custom_vlan 
keyword, you also need to specify the VLAN 
name.

The gateway IP address.

The metric (integer) for this route. The number can 
be from 2 to 15.

FVS318N> net routing static ipv4 configure Orly 

net-config[static-routing-ipv4]> active_flag Y 

net-config[static-routing-ipv4]> private_flag Y 

net-config[static-routing-ipv4]> destination_address 10.118.215.178 

net-config[static-routing-ipv4]> subnet_mask 255.255.255.0 

net routing static ipv4 configure <route name>

active_flag {Y | N}

private_flag {Y | N}

destination_address <ipaddress>

subnet_mask <subnet mask>

interface {custom_vlan <VLAN name> | dmz | lan | wan}

gateway_address <ipaddress>

metric <number>

destination_address ipaddress