Netgear FVS318N – Prosafe Wireless N VPN Firewall 快速安装指南

If you have difficulty connecting over an IPv6 connection, there might be an incorrect 
configuration on the wireless VPN firewall or the computer from which you are trying to 
connect to the wireless VPN firewall:



By default, the wireless VPN firewall is set to IPv4-only mode. Make sure that the wireless 
VPN firewall is set to IPv4/IPv6 mode (see 

Make sure that the ISP settings are correct (see 

on page 4). The wireless VPN firewall cannot receive a valid IPv6 address if 

the Internet connection is not correctly configured.

Make sure that the wireless VPN firewall can provide IPv6 addresses to the computers on 
the LAN (see 

on page 9). Check the settings on 

the LAN Setup (IPv6) screen.



Make sure that the operating system supports IPv6. Normally, the following operating 
systems support IPv6:

Windows 7, all 32- and 64-bit versions

Windows Vista, all 32- and 64-bit versions

Windows XP Professional SP3 (32- and 64-bit)

Windows Server 2008, all versions

Windows Server 2008 R2, all versions

Windows Server 2003, all versions

Windows Server 2003 R2, all versions

Linux and other UNIX-based systems with a correctly configured kernel

MAC OS X

Make sure that IPv6 is enabled on the computer.

Make sure that the computer has an IPv6 address. If the computer has a link-local 
address only, it cannot reach the wireless VPN firewall or the Internet. 

If your wireless VPN firewall can obtain an IP address, but an attached computer is unable to 
load any web pages from the Internet, check the following:

Your computer might not recognize any DNS server addresses. 

Your computer might not have the wireless VPN firewall configured as its TCP/IP 
gateway.