Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch 参考手册

7-6

Advanced Configuration

2. Type a route name for this static route in the Route Name box.

(This is for identification purpose only.) 

3. Select Private if you want to limit access to the LAN only. The static route will not be reported 

in RIP. 

4. Select Active to make this route effective. 

5. Type the Destination IP Address of the final destination. 

6. Type the IP Subnet Mask for this destination.

If the destination is a single host, type 255.255.255.255. 

7. Type the Gateway IP Address, which must be a firewall on the same LAN segment as the 

firewall. 

8. Type a number between 1 and 15 as the Metric value. 

This represents the number of firewalls between your network and the destination. Usually, a 
setting of 2 or 3 works, but if this is a direct connection, set it to 1. 

9. Click Apply to have the static route entered into the table. 

As an example of when a static route is needed, consider the following case:

•

Your primary Internet access is through a cable modem to an ISP.

•

You have an ISDN firewall on your home network for connecting to the company where 
you are employed. This firewall’s address on your LAN is 192.168.0.100.