KitchenAid 30" Vented 400-CFM Wall-Mount Canopy Hood 使用和维护

1. Disconnect power.

2. Remove terminal box cover.

3. Remove the knockout in the terminal box and install 

a UL listed or CSA approved

 ¹⁄₂" strain relief.

4. Run home power supply wiring through 

¹⁄₂" strain relief 

into terminal box.

5. Use UL listed wire connectors and connect white 

wires (B) together.

6. Use UL listed wire connectors and connect black 

wires (C) together.

7. Connect green (or bare) ground wire from home power supply 

to the 2 yellow-green ground wires (D) in terminal box using 
UL listed wire connectors.

8. Tighten strain relief screw.

9. Install terminal box cover.

10. Reconnect power.

1. When using both upper and lower vent covers, push lower 

cover down onto hood and lift upper cover to ceiling and 
install with (2) 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may 
be reversed to hide slots.

1. For non-vented (recirculating) installations only, install 

charcoal filters over the grease filters, using the clips 
provided in the kit. See the “Range Hood Care” section.

2. Install metal filters. See the “Range Hood Care” section.

3. Check the operation of the range hood blower and light. 

See the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range 
hood, read the “Range Hood Use” section.

A

B

C

D

E

A

B

C

C

D