KitchenAid 30" Vented 400-CFM Wall-Mount Canopy Hood 使用和维护

IMPORTANT: Clean the hood and grease filters frequently 
according to the following instructions. Replace grease filters 
before operating hood.

To avoid damage to the exterior surface, do not use steel wool 
or soap-filled scouring pads. 

Always wipe dry to avoid water marks.

■

Liquid detergent soap and water, or all-purpose cleanser

■

Wipe with damp soft cloth or nonabrasive sponge, then 
rinse with clean water and wipe dry.

1. Remove each filter by pulling the spring release handle 

and then pulling down the filter. 

2. Wash metal filters as needed in dishwasher or hot detergent 

solution.

3. Reinstall the filter by making sure the spring release handles 

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.

The charcoal filter is not washable. It should last up to 6 months 
with normal use. Replace with Charcoal Filter Kit. See the 
“Assistance or Service” section for information on ordering.

1. Remove metal grease filter from range hood. See “Metal 

Grease Filter” in this section.

2. Bend spring clips away from metal grease filter. 

3. Place charcoal filter into top side of metal filter.

4. Bend spring clips back into place to secure the charcoal 

filter to the metal filter. 

5. Replace metal grease filter. See “Metal Grease Filter” in 

this section.

Turn off the range hood and allow the bulb to cool. To avoid 
damage or decreasing the life of the new bulb, do not touch 
bulb with bare fingers. Replace bulb using tissue or wearing 
cotton gloves to handle bulb.

If new bulbs do not operate, make sure the bulbs are inserted 
correctly before calling service.

1. Disconnect power.

2. Use the T10 Torx

®

 adapter with a Phillips screwdriver to 

remove screw from lens cover.

3. Remove lens cover and set lens cover and the screw aside.

4. Remove bulb and replace with a new 120 volt, 40 watt 

maximum E-12 bulb. 

5. Replace lens cover and reinstall screw.

6. Repeat steps 2-5 for the other bulb.

7. Reconnect power.

A

B

A