Xerox Phaser 4600/4620 管理员指南

Network Installation

Phaser 4600/4620
System Administrator Guide

24

SNMP Configuration

Allows you to configure the following options when accessing the machine via SNMP v1/v2c.

Protocol Enable – Allows you to enable or disable the SNMP v1/v2c protocols.

Edit SNMP Properties – Displays the page which allows you to set the following SNMP v1/v2c 
properties.

•

GET Community Name (Read Only) – Enter the community name used for display.

•

SET Community Name (Read/Write) – Enter the community name used for display and 
update.

•

TRAP Community Name – Enter the trap notification community name.

•

Enable – When the Authentication Failure Generic Trap is enabled, this machine will generate 
a trap for every SNMP request that is received by the machine which contains an invalid 
community name.

•

IP Address: Enter the IPv4 address of the SNMP agent that you are setting up to receive 
traps.

•

UDP Port Number: Enter the UDP port number of the SNMP agent.

•

TRAP Community Name: Enter the trap community name of the SNMP agent.

•

Trap to be Received: Select the types of traps to receive from the SNMP agent

Allows you to configure the following options when accessing the machine via SNMP v1/v2c.

•

Context name: enter the name that allows the SNMPv3 agent to identify the management 
information associated with the machine.

•

User Name: enter the username required for SNMPv3 authentication.

•

Authentication Password: enter the password required for SNMPv3 authentication.

•

Algorithm: Select the algorithm to be used to encrypt the user authentication information. 
MD5 or SHA may be used but the algorithm must match that used by the SNMPv3 agent. 

•

Privacy password: enter the password required for SNMPv3 packet encryption authentication.

•

Algorithm: displays the algorithm used for packet encryption, in the case of SNMPv3 this is 
the DES encryption method.