Xerox Phaser 780 Tabloid 安装指南

To set up the printer for DNS, you must supply an IP domain name and up to two 
DNS name server IP addresses. There are three ways to set up the printer for DNS:

■

BOOTP.  See “Setting IP parameters: RARP or BOOTP” on page 65 and 
“Supported BOOTP/DHCP fields” on page 68.

■

DHCP.  See “Setting IP parameters: DHCP” on page 66 and “Supported 
BOOTP/DHCP fields” on page 68.

■

On any system that supports TCP/IP, you can use PhaserLink Printer 
Management Software.  See the next topic, “Setting up the printer for DNS 
using PhaserLink Printer Management Software”."

After setting the printer’s IP address by one of the methods described previously in 
this chapter, you can set up the printer for DNS using PhaserLink software, if you 
have a World Wide Web browser.  For more information on PhaserLink software, see 
Chapter 12, “PhaserLink Printer Management Software”.

From the printer’s home page, click Configuration; this displays the View 
and Configure Settings

 page.

From the View and Configure Settings page, click View and Configure 
Interface Settings

; this displays the View and Configure Interface 

 page.

From the View and Configure Interface Settings page, click View and 
Configure TCP/IP Settings

; this displays the View and Configure TCP/IP 

 page.    

Set the Domain Name Service Resolver Enabled field Yes.

Enter the following information:

■

Primary Name Server IP Address (required)

■

Second Name Server IP Address (optional)

■

IP Domain Name  (required)

■

Additional Search Domain Name(s) (optional)

When you are finished entering the settings, enter the Validation Password 
and click Do/Apply. 

The printer responds by displaying a dialog box that allows you to reset the 
printer.  The new parameters will not take effect until the printer is reset.