Xerox Phaser 750 安装指南
30
PhaserShare Networking Manual
TCP/IP Host Configuration (UNIX)
Configuration procedures for common System V
UNIX hosts
UNIX hosts
Sun Solaris
For Solaris version 2.6 and later, go to Adding an LPD queue in Solaris on page 31. For
Solaris 2.5x and older, use the sol_apps.tar provided with your printer’s networking
software to avoid a Solaris communication problem. The sol_apps.tar file is also available
from the Tektronix ftp site:
Solaris 2.5x and older, use the sol_apps.tar provided with your printer’s networking
software to avoid a Solaris communication problem. The sol_apps.tar file is also available
from the Tektronix ftp site:
ftp.tek.com/cpid/UNIX/sun/sol_apps.tar
This file redirects the print jobs to the printer's AppSocket port (port 9100) instead of the
LPD port (port 515).
LPD port (port 515).
Note
If you do not want to redirect the print jobs to the printer's AppSocket port, see
Adding an LPD queue in Solaris on page 31.
Adding an LPD queue in Solaris on page 31.
1.
Untar the sol_apps.tar file by typing this command:
2.
Edit the file /etc/hosts to create an entry for the printer.
3.
Execute the following commands:
The print queue is now enabled.
tar -xvf phaser.sun5
The following files are extracted into the indicated directories:
asprint.sun5 to /usr/bin
tektcp.sun5 to /usr/spool/lp/model
Note
The network name and the queue name for your printer must be identical
for the model file to work.
for the model file to work.
lpadmin -p queuename -v /dev/null -i /usr/spool/lp/model/tektcp.sun5 -I postscript
enable queuename
accept queuename
where queuename is the name entered for the printer in the /etc/hosts file.