Xerox Phaser 790 用户指南
11. Installing user software in a Windows NT 4.0 environment
Xerox Phaser 790
11–3
Installing the user software for parallel port printing
(Windows NT 4.0)
(Windows NT 4.0)
Use this procedure to install the printer. It prepares your system for
local printing through the parallel port.
local printing through the parallel port.
Before you begin, print a Configuration Page for the printer. For
specific procedures, refer to the chapter Performing the setup from the
Printer Control Panel.
specific procedures, refer to the chapter Performing the setup from the
Printer Control Panel.
If you have previously installed a print driver for the Phaser 790, perform the
uninstall procedure before installing the new driver. For more information,
refer to your Windows documentation.
uninstall procedure before installing the new driver. For more information,
refer to your Windows documentation.
1.
Insert the User Software CD in your CD-ROM drive.
2.
Select Start, Settings, and Printers.
3.
Double-click Add Printer to display the Add Printer wizard.
Select Next.
Select Next.
4.
To install a printer locally, select My Computer and select Next.
My Computer is available if you logged in to a workstation on
which you have Administrator privileges. If it is not available, add
a network printer and follow the procedure for adding a port.
Refer to the section Installing the user software for TCP/IP and
LPR printing for Windows NT 4.0 in this chapter.
which you have Administrator privileges. If it is not available, add
a network printer and follow the procedure for adding a port.
Refer to the section Installing the user software for TCP/IP and
LPR printing for Windows NT 4.0 in this chapter.