Xerox Phaser 850 用户指南
Advanced Features and Troubleshooting Manual
133
Cleaning Phaser 850 Printers
Cleaning for ink smears: paper-exit path
If you have already performed the other “Cleaning for ink smears” procedures described
earlier in this chapter but problems persist, you should clean the paper-exit path. Refer
also to Cleaning for ink smears: paper-feed rollers on page 129.
earlier in this chapter but problems persist, you should clean the paper-exit path. Refer
also to Cleaning for ink smears: paper-feed rollers on page 129.
Occasionally, stray ink particles and oil become attached to the Rapid Release Guide,
rollers, and guides under the exit cover causing ink streaks or marks on the top edge, front,
or back of prints. When this occurs, you must clean these parts using alcohol-soaked
wipes.
rollers, and guides under the exit cover causing ink streaks or marks on the top edge, front,
or back of prints. When this occurs, you must clean these parts using alcohol-soaked
wipes.
Sample ink smear: paper-exit path
1.
To clean the rubber exit rollers:
a.
Wrap an alcohol-soaked wipe around the index finger of one hand.
b.
Press your wipe-covered finger against each roller.
Caution
To avoid damaging the print drum and Rapid Release Guide, never use any
sharp objects in this area, or scrape excess ink with a tool or fingernail.
sharp objects in this area, or scrape excess ink with a tool or fingernail.
9103-13