Xerox DocuColor 12 Printer with Splash G620 用户指南

Before handling Splash server interface cards, attach the 3M

™

 Disposable Grounding Wrist Strap to 

your wrist. The wrist strap is provided to route static electricity away from sensitive components 
while you handle them, particularly while you populate the Splash card with the provided Memory 
DIMMs, and while you install the Splash card in the Power Macintosh. Failure to wear the wrist 
strap can result in damage to the card or to your computer.

Follow these steps to attach the wrist strap:

Unwrap the first two folds of the wrist strap and wrap the exposed adhesive side firmly around 
your wrist.

Unroll the rest of the wrist strap and peel the liner from the copper foil at the opposite end.

Remove the cover of you Macintosh according to the instructions that came with it.

Attach the copper foil to the exposed metal on the Macintosh power supply.

The 3M Disposable Grounding Wrist Strap discharges static electricity that accumulates on your 
body. It will neither increase nor decrease your risk of electrocution when using or working on 
electrical equipment. Follow the same safety precautions you would use without the wrist strap.

•

Ground equipment properly.

•

Avoid touching grounded objects unless you are wearing the 3M Disposable Grounding Wrist 
Strap.

•

Do not use the wrist strap in areas where you might contact electrical circuitry exceeding 250 
volts.

To avoid risk of damage, always shut down the Splash server and turn off power to the Xerox 
DocuColor 12 Copier/Printer when you disconnect the printer cable from the Splash server or from 
the Xerox DocuColor 12 Copier/Printer.

To disconnect the interface cable from the Splash server:

Shut down the Splash server, then turn off the display and all peripheral devices.

Turn off the Xerox DocuColor 12 Copier/Printer.

Squeeze the metal buttons on each side of the connector to release the cable from the interface 
card port on the back of the Splash server.

Gently pull the cable out of the port.

Repeat steps 3 and 4 to remove the second cable.

Restart the Macintosh and the Xerox DocuColor 12 Copier/Printer.