Xerox DocuColor 12 Printer with Fiery X12 安装指南

 

Installation can be performed by a network or printing administrator. The stages of a 
successful installation are:

 

Prepare a network node for the Fiery—obtain cable and route it to the location 
where the Fiery will be installed (near the copier) and attach the cable to the network 
interface of the Fiery. See page 2-10 for details.

 

If you plan to run the Command WorkStation software from a remote 

computer, you will need to install the software and connect the Command 
WorkStation computer to the network along with the Fiery. See 

 

 

for details.

 

When network servers are required, you need to configure those servers to provide 
client access to the Fiery as a color PCL or PostScript printer. See Chapter 5 for 
information on configuring network servers in Windows and UNIX network 
environments.

 

Configure the Fiery for your particular printing and network environment. First 
read Chapter 2, and then see the following chapters for details.

Install the files needed for printing, install additional user software, and connect the 
client to the Fiery over the network. These steps are described in Getting Started, and 
some information is provided in Chapter 5 of this manual.

Monitor and maintain system performance and troubleshoot problems that arise. 
See Chapter 6 and the Job Management Guide for details.