Xerox DocuColor 12 Printer with Fiery X12 安装指南

This option appears only if Enable Parallel Port is set to Yes. Your setting determines 
how long (in seconds) the Fiery waits without receiving data from the parallel port 
before deciding that the current job is complete. Until the timeout, the Fiery cannot 
receive new jobs through the parallel port, but it can continue to receive network print 
jobs.

This option appears only if Enable Parallel Port is set to Yes. This option specifies that 
the Fiery should ignore end-of-file (EOF) messages in a file. This option must be set to 
Yes to print PostScript files in binary format (not ASCII); under normal circumstances, 
it should be set to No. When this option is set to Yes, the Fiery uses the parallel port 
timeout value to determine when the end of the file has been reached. If you 
experience printing problems, set this option to No.

The Fiery searches the network for AppleTalk zones in your network segment. Scroll 
through the list to select the AppleTalk zone in which you want the Fiery to appear. If 
your segment has only one zone, the Fiery is assigned to that zone automatically.

The message “No AppleTalk zone found” may mean your network has no zones, or the 
network cable is not connected (see page 6-4). Choose OK to dismiss the message.

To configure the Fiery, choose each protocol and enter the settings for that 
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication 
simultaneously.

Network Setup

Protocol Setup

Select Yes if you have an AppleTalk network connected to the Fiery. This 
setting enables the Fiery to communicate over AppleTalk networks.