Honeywell TH1100DV 安装指南
Installation Guide
2
69-2800EFS—01
C IS OPTIONAL
WITH BATTERIES
NOT
USED
R
C
AUX/
AUX/
E
Y
G
O
B
M34682
Wallplate installation
Remove the wallplate from the thermostat
as shown at left, then follow directions
below for mounting.
as shown at left, then follow directions
below for mounting.
1. Pull wires through wire hole.
2. Position wallplate on wall, level and mark hole
positions with pencil.
3. Drill holes at marked positions as shown below,
then tap in supplied wall anchors.
4. Place wallplate over anchors, insert and tighten
mounting screws.
Pull at bottom to remove thermostat from
wallplate.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before beginning
Can cause electrical shock or equipment damage. Disconnect power before beginning
installation.
Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not place
If this product is replacing a control that contains mercury in a sealed tube, do not place
the old control in the trash. Contact the Thermostat Recycling Corporation at
www.thermostat-recycle.org or 800-238-8192 for information on how and where to properly
and safely dispose of your old thermostat.
M34683
Wall anchors
Mounting screws
Wire hole