Zanussi ZGG96624XA 用户手册

Model .......................................

PNC .........................................

Serial number ...........................

This hob must be installed in accordance with

the Gas Safety (Installation and Use)

Regulations (Current Edition) and the IEE

Wiring Regulations (Current Edition).
For appliances installed in the Republic of

Ireland please refer to NSAI- Domestic Gas

Installation I.S. 813 Current Editions and the

ETCI Rules for Electrical Installations.
Provision for ventilation

Detailed recommendations are contained in the

following British Standards Codes Of Practice:

B.S. 6172/B.S. 5440, Par. 2 and B.S. 6891

Current Editions.
The hob should not be installed in a bed sitting

room with a volume of less than 20 m³. If it is

installed in a room of volume less than 5 m³ an

air vent of effective area of 100 cm² is required.

If it is installed in a room of volume between 5

m³ and 10 m³ an air vent of effective area of 50

cm² is required, while if the volume exceeds 11

m³ no air vent is required.
However, if the room has a door which opens

directly to the outside no air vent is required

even if the volume is between 5 m³ and 11 m³.
If there are other fuel burning appliances in the

same room, B.S. 5440 Part 2 Current Edition,

should be consulted to determine the requisite

air vent requirements.
For appliances installed in the Republic of

Ireland please refer to the NSAI- Domestic Gas

Installation I.S. 813 Current Editions Table Four.
Location

The hob may be located in a kitchen, a kitchen/

diner or bed sitting room (with a volume greater

than 20 m³), but not in a bathroom or shower

room.
The minimum distance combustible material can

be fitted above the hob in line with the edges of

the hob is 400 mm. If it is fitted below 400 mm

a space of 50 mm must be allowed from the

edges of the hob.
For appliances installed in the Republic of

Ireland please refer to NSAI- Domestic Gas

Installation I.S 813 Current Edition Section 7-

Permitted Locations of Appliance.

Any gas installation must be carried

out by a GAS SAFE REGISTER

installer.

Make sure that, once the hob is installed, it is

easily accessible for the engineer in the event of

a breakdown.
The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this instruction

booklet be ignored.
On the end of the shaft, which includes the G

1/2" threaded elbow, adjustment is fixed so that

the washer is fitted between the components as

shown in the diagram. Screw the parts together

without using excessive force.

A) End of shaft with nut

B) Washer

C) Elbow

Connection to the gas supply should be with

either rigid or semi-rigid pipe, i.e. steel or

copper.
The connection should be suitable for

connecting to R 1/2 (1/2 BSP male thread).
When the final connection has been made, it is

essential that a thorough leak test is carried out

on the hob and installation.
Make sure that the main connection pipe does

not exert any strain on the hob.
If you use flexible metal pipes make sure that

they agree to ISO 10380 and ISO 10807

standards. Be careful they do not come in touch

with mobile parts or they are not squeezed. Also

be careful when the hob is put together with an

oven.