Cisco Cisco Physical Access Reader Module 安装指南
Installing Cisco Network Modules and Service Modules in Cisco Access Routers
Installing Cisco Interface Cards in 1- or 2-Slot Network Modules
28
Installing Cisco Network Modules and Service Modules in Cisco Access Routers
OL-20790-02
Step 6
Remove the network module, using the procedure described in the
Step 7
Install the replacement network module, using the procedure described in the
.
Step 8
Check that the network module LEDs come on and that the Active/Ready LEDs on the router front panel
also come on. This inspection ensures that connections are secure and that the new unit is operational.
also come on. This inspection ensures that connections are secure and that the new unit is operational.
Step 9
Initiate a network module console session with the following command:
Router# service-module service-engine slot/port session
Trying 10.10.10.1, 2129 ... Open
SE-netmodule con now available
Press RETURN to get started!
SE-netmodule> enable
SE-netmodule#
Step 10
Restore the running configuration for the network module with the following command from the
SE-netmodule prompt:
SE-netmodule prompt:
SE-netmodule# copy ftp: running-config
Address or name or remote host? username/password/remote host
Source filename? filename
Step 11
Exit the network module console session by pressing Ctrl-Shift-6, followed by x.
Step 12
On the router, clear the console session using the following command:
Router# service-module service-engine slot/port session clear
Installing Cisco Interface Cards in 1- or 2-Slot Network Modules
Some network modules have one or two interface card slots, which support a variety of voice and data
interface cards.
interface cards.
Note
Do not install an ISDN BRI WAN interface card or an ISDN BRI network module in the same chassis
as an ISDN PRI network module unless you are using Cisco IOS Release 11.3(3)T or later.
as an ISDN PRI network module unless you are using Cisco IOS Release 11.3(3)T or later.
Note
Do not install newer BRI WAN interface cards in the same network module as older BRI WAN interface
cards. To identify newer BRI WAN interface cards, examine the B-channel LEDs. Newer BRI WAN
interface cards have B-channel LEDs that are arranged horizontally. Older BRI WAN interface cards
have B-channel LEDs that are arranged vertically.
cards. To identify newer BRI WAN interface cards, examine the B-channel LEDs. Newer BRI WAN
interface cards have B-channel LEDs that are arranged horizontally. Older BRI WAN interface cards
have B-channel LEDs that are arranged vertically.
To install an interface card in a 1- or 2-slot network module, perform the following steps: