Cisco Cisco Physical Access Reader Module 安装指南
Installing Cisco Network Modules and Service Modules in Cisco Access Routers
Installing Other Accessories on Cisco Network Modules
30
Installing Cisco Network Modules and Service Modules in Cisco Access Routers
OL-20790-02
Figure 23
Installing an Interface Card in a Network Module (Typical)
Step 5
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws into the holes
on the network module faceplate.
on the network module faceplate.
Step 6
Reinstall the network interface cables and power up the router.
The following warning applies to routers that use a DC power supply:
Warning
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position. Statement 8
reinstate power by moving the handle of the circuit breaker to the ON position. Statement 8
Installing Other Accessories on Cisco Network Modules
Some Cisco network modules support a variety of additional modules, such as gigabit interface
converters (GBICs) and small form-factor pluggable modules (SFPs).
converters (GBICs) and small form-factor pluggable modules (SFPs).
Replacing Hard Drives on Service Modules
The service module must be running in the Redundant Array of Inexpensive Hard Disks (RAID) mode
(RAID 1), to perform an online insertion and removal of the faulty drive with a good replacement drive.
(RAID 1), to perform an online insertion and removal of the faulty drive with a good replacement drive.
1
Interface card
2
2-slot network module
2E
2W W1
2W W1
ETH 1
ETHERNET 0
AUI
EN
ACT
LNK
ACT
LNK
BRI
S/T
B1
B2
WO
H7219
1
2