Cisco Cisco ONS 15310-MA SDH Multiservice Platform 安装指南

Wait one minute before restoring the next node.

You have now completed the manual database restore.

When the complete database is restored, the node does not report an event regarding the IP 
change; the node reboots and configures the new IP from the database. If the IP address being 
restored is not in the CTC network IP addressing scheme, you might lose visibility of the node. 
To resolve this, you must launch CTC with the IP mentioned in the table against the database 
backup. Refer to Table 1 “Manually Recorded Data” in the 

 for more information. 

Return to your originating procedure (NTP).

This procedure assumes you are upgrading using Release 6.x TL1 syntax. TL1 commands issued prior 
to software activation to Software R9.2.1.3 varies in syntax depending on the release you are actually 
upgrading from. To ensure that your syntax for each command is correct, use the TL1 syntax supplied 
in the Cisco ONS 15454 SDH, Cisco ONS 15600 SDH, and Cisco ONS 15310-MA SDH TL1 Command 
Guide for your particular release when issuing the following commands:

ACT-USER

COPY-RFILE

REPT-EVT-FXFR

OPR-PROTNSW-<OCN_TYPE>

RTRV-COND-ALL

RTRV-ALM-ALL

This procedure upgrades the software to R9.2.1.3 using TL1 rather than 
CTC.

PC or UNIX workstation

NTP-U487 Preparing to Upgrade to a New Release, page 3
NTP-U481 Back Up the ONS 15310-MA SDH Software Database, 
page 4

Optional

Onsite or remote (but in the presence of the workstation)

Superuser