Cisco Cisco ONS 15310-MA SDH Multiservice Platform Guía De Instalación
15
Upgrading the Cisco ONS 15310-MA SDH to Release 9.2.1.3
OL-26732-01
DLP- U543 Manually Restore the Database
Wait one minute before restoring the next node.
Step 6
You have now completed the manual database restore.
Note
When the complete database is restored, the node does not report an event regarding the IP
change; the node reboots and configures the new IP from the database. If the IP address being
restored is not in the CTC network IP addressing scheme, you might lose visibility of the node.
To resolve this, you must launch CTC with the IP mentioned in the table against the database
backup. Refer to Table 1 “Manually Recorded Data” in the
change; the node reboots and configures the new IP from the database. If the IP address being
restored is not in the CTC network IP addressing scheme, you might lose visibility of the node.
To resolve this, you must launch CTC with the IP mentioned in the table against the database
backup. Refer to Table 1 “Manually Recorded Data” in the
for more information.
Step 7
Return to your originating procedure (NTP).
NTP-U513 Upgrade to the ONS 15310-MA SDH Software Using
TL1
TL1
Note
This procedure assumes you are upgrading using Release 6.x TL1 syntax. TL1 commands issued prior
to software activation to Software R9.2.1.3 varies in syntax depending on the release you are actually
upgrading from. To ensure that your syntax for each command is correct, use the TL1 syntax supplied
in the Cisco ONS 15454 SDH, Cisco ONS 15600 SDH, and Cisco ONS 15310-MA SDH TL1 Command
Guide for your particular release when issuing the following commands:
to software activation to Software R9.2.1.3 varies in syntax depending on the release you are actually
upgrading from. To ensure that your syntax for each command is correct, use the TL1 syntax supplied
in the Cisco ONS 15454 SDH, Cisco ONS 15600 SDH, and Cisco ONS 15310-MA SDH TL1 Command
Guide for your particular release when issuing the following commands:
•
ACT-USER
•
COPY-RFILE
•
REPT-EVT-FXFR
•
OPR-PROTNSW-<OCN_TYPE>
•
RTRV-COND-ALL
•
RTRV-ALM-ALL
Purpose
This procedure upgrades the software to R9.2.1.3 using TL1 rather than
CTC.
CTC.
Tools/Equipment
PC or UNIX workstation
Prerequisite Procedures
NTP-U487 Preparing to Upgrade to a New Release, page 3
NTP-U481 Back Up the ONS 15310-MA SDH Software Database,
page 4
NTP-U481 Back Up the ONS 15310-MA SDH Software Database,
page 4
Required/As Needed
Optional
Onsite/Remote
Onsite or remote (but in the presence of the workstation)
Security Level
Superuser