Cisco Cisco NSS030 Smart Storage External Power Adapter 维护手册

Troubleshooting Abnormal RAID Operation of Your NAS

Cisco Small Business NSS300 Series Smart Storage Administration Guide

282

 

To troubleshoot abnormal RAID operation of your NAS, follow these steps:

Check whether the RAID rebuilding has failed.

When the RAID rebuilding fails:

•

The Status light of the NAS blinks red.

•

In the Disk Management > Volume Management window of the web-based 
configuration utility of the NAS, the status of the disk volume configuration is 
“In degraded mode.”

Determine which hard drives caused the RAID rebuilding failure.

In the web-based configuration utility of your NAS, open the System 
Administration > System Logs window and search for error messages similar to 
the following sample message:

Error occurred while accessing Drive 2.
Drive 2 has been removed.

This message indicates that the hard drive in slot 2 has failed.

Replace the failed drives with new drives.

After inserting the new hard drives, the RAID rebuilding should start.

If the rebuilding succeeds, the NAS will return to normal operation. Skip the 
remaining steps.

If the rebuilding fails again due to a read/write error, continue the troubleshooting.

Determine which hard drives caused the error.

•

If the error is caused by one of the new drives, go back to 

.

•

If the error is caused by an old drive, go to 

If the RAID configuration is RAID 1, do one of the following:

Reinstall and set up the NAS:

a. If you haven’t done so already, back up the drive data to another storage 

device.

b. Reinstall and set up the NAS.