Cisco Cisco Unified MeetingPlace Audio Server 维护手册
4-53
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
Step 7
Select the appropriate protocol table number. In this example, it is protocol table 0, so type
0
and press
Enter. Refer to
for a list of default protocol tables.
Note
The protocol table contains the configuration information for the type of signaling used. All E1
systems are shipped from the factory with protocol table 0 set to use the default setting of Euro
ISDN protocol and protocol table 1 to use the QSIG protocol. If this is not correct for your
system, it can be changed via the “protparm” command. Refer to the
systems are shipped from the factory with protocol table 0 set to use the default setting of Euro
ISDN protocol and protocol table 1 to use the QSIG protocol. If this is not correct for your
system, it can be changed via the “protparm” command. Refer to the
for more information on the “protparm” command.
Note
If this is part of an upgrade from a pre-5.1 release, the default protocol tables 3 and 4 will not
be correct. To resolve this, use the “protparm” command to delete tables 3 and 4. This restores
them to the defaults as listed in
be correct. To resolve this, use the “protparm” command to delete tables 3 and 4. This restores
them to the defaults as listed in
.
Step 8
Repeat this procedure if more than one port group is needed.
Step 9
Type
x
and press Enter to exit the “port” utility.
Note
There are two QSIG variants: QSIG ECMA and QSIG ETSI. You must be sure to use the same
variant that the customer’s PBX is set up to use. QSIG ECMA is the default for protocol table 1.
If QSIG ETSI is needed, the default protocol must be changed.
variant that the customer’s PBX is set up to use. QSIG ECMA is the default for protocol table 1.
If QSIG ETSI is needed, the default protocol must be changed.
Assigning ports to port groups
You can assign specific ports to port groups so that all ports in that group have the same parameters.
Step 1
At the tech$ prompt, type
port
and press Enter.
appears.
Step 2
Type
2
and press Enter to modify a port record. The first line in
appears.
Figure 4-59 Assigning Port Record
Table 4-8
Default Protocol Table Settings — E1
Protocol Table
Number
Number
Default Protocol
0
Euro ISDN
1
QSIG ECMA
Enter port record number [0..7] : 0
------------- UNIT 0 PORT 0 --------------
--- To skip over a field, just press <cr> ---
Uses port group [ 0] : 0