Cisco Cisco Unified MeetingPlace Audio Server 维护手册
5-21
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing a Multi Access Blade
Replacing a Multi Access Blade
This section provides instructions on how to replace a Multi Access Blade’s card and transition module.
Warning
Handling these cards can result in static damage. Use an anti-static wrist strap, static-dissipating
work surface, and anti-static bags when handling and storing these cards.
work surface, and anti-static bags when handling and storing these cards.
Note
Each Multi Access Blade card has a transition module in the same slot in the back of the server.
Whenever a Multi Access Blade card is replaced, its corresponding transition module must also be
replaced.
Whenever a Multi Access Blade card is replaced, its corresponding transition module must also be
replaced.
Removing an old Multi Access Blade card
Step 1
Verify all steps in the section the
have been completed.
Step 2
Verify which Multi Access Blade card needs replacing. Locate the two red plastic latches on the left and
right of the card within each black plastic handle.
right of the card within each black plastic handle.
Step 3
Press on both red latches and release them.
Step 4
Lift both of the black plastic handles to unseat the Multi Access Blade card.
Step 5
Gently pull the Multi Access Blade card out of the chassis.
Installing a new Multi Access Blade card
Step 1
Ensure that the system is powered down. If you are installing a new Multi Access Blade card
immediately after removing an old one, the system should still be powered down. Otherwise, follow the
steps in the
immediately after removing an old one, the system should still be powered down. Otherwise, follow the
steps in the
Step 2
Verify which slot number the new Multi Access Blade card is going into.
Step 3
Gently insert the Multi Access Blade card horizontally into the server’s slot. As the card is inserted, the
black plastic handles on the left and right of the card’s front panel must engage with the chassis. When
the card is firmly mounted into the correct position inside the chassis, the red plastic latches within each
handle self-lock.
black plastic handles on the left and right of the card’s front panel must engage with the chassis. When
the card is firmly mounted into the correct position inside the chassis, the red plastic latches within each
handle self-lock.
Step 4
Verify the black handles are in their locked position.
Removing an old Multi Access Blade transition module
Step 1
Verify all steps in the section the
have been completed.
Step 2
Verify which Multi Access Blade transition module needs replacing. Locate the two red plastic latches
on the left and right of the transition module within each black plastic handle.
on the left and right of the transition module within each black plastic handle.