Cisco Cisco Unified MeetingPlace Audio Server 维护手册
5-2
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
•
•
•
•
•
Step 4
Power up MeetingPlace. Refer to
Scheduling the repair
Before going to the customer site, arrange with the customer site contact for a no-meeting period for the
amount of time the repair requires.
amount of time the repair requires.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Statement 1030
Preparing for the repair
This section explains the steps that need to be performed prior to replacing any of the FRUs mentioned
in this chapter.
in this chapter.
Step 1
Inspect the piece of new hardware to verify no damage occurred in transit.
Step 2
Verify your toolkit contains the correct tools for the repair. Refer to
for
a list of required tools.
Note
If you are replacing either of the power supply units, you do not need to complete the rest of this section.
Go directly to the
Go directly to the
.
Verifying no user activity
This section explains how to verify there is no user activity on the system before shutting it down for the
repair.
repair.
Step 1
If not already connected, access the command line interface (CLI) by following the procedures in the
Note
CLI commands are case sensitive. For CLI command information, refer to
Step 2
Log in as technician. The tech$ prompt appears.