Cisco Cisco Unified MeetingPlace Audio Server 维护手册
3-10
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Unpacking the 8106 server
To unpack the 8106 server, perform the following steps:
Step 1
Remove the shipping material.
Step 2
Inspect for damage.
Step 3
Verify the contents of the boxes.
Removing the shipping material
Warning
The server, its peripheries, and the packing materials can weigh up to 75 lbs (34 kg).
1.
Make sure the packing carton is upright.
2.
Carefully cut the sealing tape with a box cutter and open the box.
3.
Remove the foam packing material.
4.
Lift the server carefully out of the carton and move it close to the location designated for the
installation.
installation.
Inspecting for damage
Visually inspect the server for damage. If the server is damaged or scratched, call the Cisco TAC for
instructions.
instructions.
Verifying the contents of the boxes
Inspect the contents of the boxes to make sure the following are included:
Note
These items are shipped in two separate boxes.
•
MeetingPlace Audio Server 5.2 for 8106 server
•
two sets of screws to mount the server onto the rack
•
power cable
•
external modem and cables (modem power cable, modem cable, and telephone extension cable)
•
IP LAN cables for Multi Access Blades (for systems using IP ports). These IP LAN cables connect
the Multi Access Blade to the customer’s LAN
the Multi Access Blade to the customer’s LAN
Note
The number of IP LAN cables you receive depends on the number of ports purchased for
your system. You need one IP LAN cable for every Multi Access Blade in your system.
your system. You need one IP LAN cable for every Multi Access Blade in your system.