Cisco Cisco Unified MeetingPlace Audio Server 维护手册
3-11
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Mounting the 8106 server
•
T1 CAS telephony cables for T1 Smart Blades (for systems using T1 CAS ports). Use these T1 CAS
telephony cables to connect the T1 Smart Blades to the customer’s system
telephony cables to connect the T1 Smart Blades to the customer’s system
Note
The number of T1 CAS telephony cables you receive depends on the number of ports
purchased for your system. You need one T1 CAS telephony cable for every 24 PSTN ports
being activated.
purchased for your system. You need one T1 CAS telephony cable for every 24 PSTN ports
being activated.
•
E1 telephony cables (for systems using E1 ports). Use these E1 telephony cables connect to the front
of the breakout box to the customer’s system
of the breakout box to the customer’s system
Note
The number of E1 telephony cables shipped with your system depends on how many Multi
Access Blades are in the system. Sixteen cables are shipped for each Multi Access Blade.
Access Blades are in the system. Sixteen cables are shipped for each Multi Access Blade.
•
T1 PRI telephony cables (for systems using T1 PRI ports). Use these T1 PRI telephony cables
connect to the front of the breakout box to the customer’s system
connect to the front of the breakout box to the customer’s system
Note
The number of T1 PRI telephony cables shipped with your system depends on how many
Multi Access Blades are in the system. Sixteen cables are shipped for each Multi Access
Blade.
Multi Access Blades are in the system. Sixteen cables are shipped for each Multi Access
Blade.
•
applicable software, manuals, and license documents
In addition, the following items are shipped with systems requiring a breakout box (T1 PRI or E1
configuration):
configuration):
•
breakout box
•
screws for mounting the breakout box
•
trunk card interface cable assemblies (50-pin Amphenol cables)
Note
The number of trunk card interface cable assemblies shipped with your system depends on
how many and the type of Multi Access Blades in the system. Two cables are shipped for
each MA-16 and one cable is shipped for each MA-4.
how many and the type of Multi Access Blades in the system. Two cables are shipped for
each MA-16 and one cable is shipped for each MA-4.
Mounting the 8106 server
You must mount and install the 8106 server in either of the following two types of racks:
•
19-inch frame relay rack
•
19-inch EIA equipment rack
This section describes how to mount and install the 8106 in a rack.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.