Cisco Cisco Unified MeetingPlace Audio Server 维护手册
3-17
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 3 Installing the 8106 Server
Connecting the system cables
Figure 3-8
8106 Server’s Power Cable Location
Connecting the LAN cable to the CPU
The LAN cable is customer-supplied and connects the 8106 server to the customer’s network. Refer to
to verify you have the correct LAN cable and connector.
Step 1
Locate the customer-supplied LAN cable.
Step 2
Plug one end of the customer-supplied LAN cable into the customer-supplied LAN socket.
Step 3
Plug the other end of the customer-supplied LAN cable into the Ethernet connection 1 on the CPU
transition module located in the back of the server. See
transition module located in the back of the server. See
Figure 3-9
CPU Transition Module
Connecting telephony cables for a T1 CAS system
All MeetingPlace servers for T1 CAS configurations are shipped with the necessary number of T1 Smart
Blades. Each T1 Smart Blade transition module in the back of the server has connectors for four trunk
lines. Looking at the back of the server, the T1 Smart Blade transition modules begin in slot 1 on the
bottom and move up to the top.
Blades. Each T1 Smart Blade transition module in the back of the server has connectors for four trunk
lines. Looking at the back of the server, the T1 Smart Blade transition modules begin in slot 1 on the
bottom and move up to the top.
The number of T1 CAS telephony cables shipped with the system depends on the number of ports being
activated. You need one T1 CAS telephony cable for every 24 ports.
activated. You need one T1 CAS telephony cable for every 24 ports.