Cisco Cisco Video Surveillance 4 Port Encoder 安装指南
6
Cisco Video Surveillance Standalone Encoder Series Quick Start Guide
OL-26254-01
Network Deployment
shows the back view of the CIVS-SENC-4P encoder.
Figure 4
CIVS-SENC-4P Back View
Network Deployment
To connect the encoder to the camera and the network, follow these steps:
Procedure
Step 1
Connect the video out socket on the camera to a BNC video input socket on the encoder. See
.
Step 2
Connect the line-out audio source on the camera to an RCA audio input socket on the encoder.
1
BNC video inputs (qty. 4)
2
RCA audio inputs (qty. 4)
12V 2A
9
8
7
6
5
4
3
2
1
1
Ethernet 10/100/1000 RJ45 port
6
SD/SDHC card slot. While the SD/SDHC slot
is on the device, it is not currently supported
by Cisco.
is on the device, it is not currently supported
by Cisco.
2
In encoders that support USB, press this
button before removing the USB device.
button before removing the USB device.
7
In encoders that support SD/SDHC, press this
button before removing the SD/SDHC device.
button before removing the SD/SDHC device.
3
Status LEDs
8
Reset button (recessed)
4
USB port. While the USB port is on the
device, it is not currently supported by Cisco.
device, it is not currently supported by Cisco.
9
Power input
5
General I/O terminal block